Mesh Grill Install

Lower Mesh Grill Install

 

XK Bumper mesh install
  1. Remove bumper center decorative chrome strip strip (8 mm wrench) and the overider plastic covers (plastic rivets).
  2. Do a test position on the grille
  3. This grille will be secured using two or four screws that will be mounted into the bumper overiders (otherwise known as the bumper guards).
    1. Powdercoated versions only need two screws.
  4. Position the grille again and make sure all ends are aligned. If the grille appears short apply pressure on the top and bottom.
  5. Make a mark where all screws will be placed.
  6. Drill a hole for the screws
  7. It is recommended that you paint the overiders a semi gloss or flat black. This can be done with regular spray paint.
  8. Again position the grille and install one or two screws on each of the bumper overiders.
  9. If screws appear to go through the mesh, use needle nose pliers to tighten the mesh strands
    10.
  10. Make final adjustments and install the second screw.

 

XK Bumper Lower mesh install

  1. Remove lower bumper diffuser (plastic unit). This will expose three holes in the bumper cover’s vertical bars
  2. Loosen lower dust shield.
  3. Install L brackets on each corner of the bumper opening (if need be position the grille first and mark install location).
  4. Position mesh grille
  5. Run three screws (through the bumper cover holes) into black clips.
  6. Run two screws through the clip on the corner L shaped brackets